Users of new purchases need to learn how to collect fingerprints, and fingerprints can be used normally after the completion of fingerprint collection.
1. Power on the attendance machine, turn on the machine, and make the machine in normal working condition.
2. Press the main menu [MENU]-[User Management]-[User Registration]-[Fingerprint Registration] on the operation panel of the time and attendance machine. The screen prompts “New Registration?†and press [OK]. At this time, you need to enter the employee ID. ,Press [OK] after confirming, the screen prompts: “Please put your fingerâ€.
3. Be careful when putting your finger down. The body of the person being gathered is standing upright relative to attendance. Put the 2/3 position of the fingertip from the tip of the fingertip on the collector's glass plate very well. Don't slide your finger, press it gently and hard, and you hear a "click" to remove your finger and perform the second 3rd press. , Press 3 times to collect a complete fingerprint.
After 4.3 presses are completed, press [OK] to save. The screen prompts: 'New registration? 'We can press [ESC] for backup registration. Each employee can collect at least 2 fingerprints for use when one of them is worn out.
5. After the backup is completed, press [OK] to save. At this time, the screen prompts: “Continue backup?†If you want to continue the backup, press [OK]. To end the backup, press [ESC] and perform fingerprint registration for the next employee.
6. After the fingerprint registration is completed, the registered finger can be used for fingerprint attendance. According to the method of pressing when collecting fingerprints, it can be done. After pressing, the screen displays the employee's job number and is accompanied by a machine voice prompt "Thank you." If the press is unsuccessful, there is a voice prompt “Please press your finger againâ€. At this time, press your finger again or replace it with another finger.
7. In the above step 6, we only saw the employee's job number, did not see the name, in fact, can display the employee's name. Please follow the steps below.
8. Install attendance management system on the computer. Insert the installation CD and follow the on-screen instructions to install it. Note that you must change the program installation path to the D drive.
9. Connect the attendance machine with the computer. The attendance machine and the computer's communication method include RS232, RS485, TCP/IP, and USB data lines.
10. Open the ETS Attendance Management System, select the device name and the corresponding connection method, click the [Connect Device] button, this will enter the fingerprint machine and the computer will be connected, you can download data, upload personnel information.
The advantage of the plastic centrifuge tube is that it is transparent or translucent, its hardness is small, and the gradient can be taken out by the puncture method. The disadvantage is that it is easy to deform, has poor corrosion resistance to organic solvents, and has a short service life.
Plastic Centrifuge Tubes have caps, which are used to prevent sample leakage, especially when used for radioactive or highly corrosive samples. It is very important to prevent sample leakage; the tube cap also has a function to prevent sample volatilization. And support the centrifuge tube to prevent deformation of the centrifuge tube. When choosing this point, you should also pay attention to check whether the tube cover is tight, and whether it can be tightly covered during the test, so as to achieve the inversion without leakage;
quick seal centrifuge tubes,laboratory centrifuge tube,pcr tube centrifuge,plastic centrifuge tubes
Yong Yue Medical Technology(Kunshan) Co.,Ltd , https://www.yongyue-tube.com