In the general intelligent parking management system, Daozou is one of the most important parts of the whole system equipment. Parking barriers are widely used in real estate, villas, toll stations, and enterprises, etc., and in smart parking. The field management system plays a role in directly handling the entrance and exit of vehicles. Therefore, the method and application of barrier devices are also very important.
There are many techniques we must pay attention to in the smart parking barrier device. At the same time, if the method is used improperly, the equipment will be prone to defects. Therefore, we pay attention to the installation and application of barrier devices in the intelligent parking management system, which can extend the service life of barriers and is not easy to damage. In general, there are the following points that need attention:
1. The general device of barriers is on the level of the road. If there is a slope, it must pay attention to the standard of the device.
2. After the line is connected, it is necessary to stop the serious test. If the test operation is abnormal, it must be reinstalled.
3, Daozha's device and the sense coil with a good harmony, the output coil twisted to the barrier gate, and the interval as short as possible, then dry cement to seal the nest.
4, the sense of the coil in the laying process can not be damaged, but also try to prevent joints, otherwise the barrier will not be able to show a normal gate, off the brakes, and the car can not automatically fall out of the gate and other problems.
5. The barricade system has adjusted the spring balance to the moment according to the length of the bar before leaving the factory. If the bar is lengthened and cut according to the site conditions, the spring force should be readjusted to equilibrium, otherwise the overheating of the motor and excessive wear of the reduction box will occur. .
Of course, the detailed device on smart parking barriers also needs to be stopped according to the system plan. Next, let's talk about the precautions to be applied in the parking lot management system.
The principle of Daozha is that the controller gives a signal to the barrier when the card is swiped. This signal controls the rotation of the motor, and the motor drives the barrier through the decelerator to control the landing and landing. When the gate closes, it gives a signal to the gate and drops the gate.
Operation barriers should pay attention to the first check the power supply voltage is consistent with the product, the machine is out of trouble, the professionals stop the maintenance, or return to the factory maintenance, in order to avoid the extension of the disease affect the subsequent application. From the date of purchase, Daozha should be replaced with a deceleration oil for one year, so as to regularly check the wires and plug-ins. The controller should adhere to cleanliness, pay attention to avoid water and other harmful substances corrosion, the use of organic solvents is strictly prohibited in the case cleaning, the controller's power supply is 12V DC, and the card reader power supply is 14V. Delay automatic stop function can be set according to the user's door stroke setting, the initial time is set to about 145 seconds. When the gate brake is commissioned, it will be shorted to the ground and the brake rod will be automatically raised to indicate that the gate is normal.
When operating the parking lot system, pay attention to vehicles and pedestrians to prevent accidental damage. The gates are generally equipped with pressure waves and will automatically spring open to prevent the brake rod from damaging the vehicle. When the power is cut off, the operation is required to open the door, when the lever is in the state of degree, directly according to the arrow of the clutch, rotate the clutch button, make it separate, the pole can implement automatic lift or manual lift, when the call comes in. , Press the OFF button, the clutch will automatically reset to the level of the brake lever and then return to normal function.
Chloride Ion Sensor
The water quality Fluoride Ion Sensor is an instrument used to detect the concentration of fluoride ions in water. The water quality fluoride ion sensor has high sensitivity and can quickly and accurately detect the concentration of trace fluoride ions in water. This has important implications for monitoring the safety of water sources and sanitary indicators of water quality. The sensor adopts advanced sensing technology, which can provide high-precision measurement results and monitor the changes of fluoride ion concentration in water in real time, and give timely feedback to users. The fluoride ion sensor is small in size, easy to operate and easy to use. Users only need to immerse the sensor in water to obtain the data of fluoride ion concentration in water. At present, fluoride ion sensors are mainly used in environmental monitoring, monitoring of fluoride ion concentration in natural water bodies, groundwater, drinking water, fluoride ion concentration in industrial production wastewater, agricultural irrigation, scientific research and other occasions. Our company also provides matching fluoride ion controllers, which can realize more abundant display, control, recording and other functions.
online chloride ion sensor, chloride ion probe, chloride ion electrode
Suzhou Delfino Environmental Technology Co., Ltd. , https://www.daruifuno.com