How to make plastic hangers

Mainly: (1) The tolerance of the jaw is at most 0.05.. (2) The thimble should be positioned well... The position of the thimble should be averaged. . Hanger molds are usually 1 out 2... thimbles together 18 sticks. The front template material is 718... The whole board is 718. The back mold is also 718.. It can be customized...because this mold is a flat plane ...in this way, the flash of the mold is also less.. Resilience.. Speaking of the product requirements.. Clamping mouth..0.05.. Please do not underestimate.. The highest requirements of the hanger mold is this small jaw. A lot of masters who have been working on molds for more than ten years are not sure... I think that flying molds can change the jaws to a small size.... This is wrong.. Big mistakes... and the hanger mold must be positioned. lock. . Waterway hanger moulds are usually pp materials.. It is also considered a daily necessities, so the batch size is relatively large~~ So the cycle of the squad is very important. If you want to speed up the friends, you can spend more renminbi.. add a ace In the back of the back mold, add a board.. Then do it in the back mold. The water tower. The water tower should run around the product. The cooling rate is super fast~~~~ The above is just how to do it.. .. and speed up production....
hope this helps. . .