1. When the crop is watered, the quantitative fertilizer is dissolved in the ditch and infiltrated into the soil around the root of the crop with the watering. This method wastes a lot of fertilizer, and is easy to leak and leak in the channel. In the deep layer that the roots of the crop cannot reach, it will also infiltrate part of the fertilizer and cause waste. The advantage is that it is simple to use, saves labor and time, and has a small amount of labor. This method can be used when the fertilizer source is sufficient, the area of ​​growing vegetables is large, and labor conflicts are prominent. It can be used as the preferred method of top dressing when large areas of vegetables have severe fat deficiency symptoms.
Second, after the crop is poured into water or after the rain, the soil is suitable for the soil, and when it is able to go to the field, the quantitative fertilizer is applied to the crop surface or the crop line. This method is also relatively simple, but there is still some fat loss in the fertilizer, especially ammonium bicarbonate is very volatile, can not be used; ammonium sulfate, urea and potassium sulfate can be applied, but only in the field is not convenient, crops need Use when the fertilizer is more urgent.
3. Buried in the crops, ditching and digging between the rows, applying the quantitative fertilizer, and then filling the soil. This method is less wasteful and economical, but it is labor-intensive, labor-intensive, and inconvenient to operate. Pay attention to safety when applying. The buried fertilizer ditch and pit should be more than 10cm away from the base of the crop stem. If it is too close to the root, it is easy. Damage to the root system. Due to the concentration of fertilizer and the high concentration, this method should not be used in the summer when crops are vigorously growing and water is needed, and it cannot be used in the critical period of crop water demand. Generally, in the winter idle season, when the labor force is sufficient and the amount of crop growth is small, this method can be used to gradually decompose the buried fertilizer and continuously supply the crop. However, in actual production, the peak of crop growth is often the peak of fertilizer demand. Therefore, the method of burying is often used at higher temperatures. In order to prevent negative effects, water must be watered after burying to reduce the concentration of fertilizer applied.
IV. Facility pursuit In recent years, with the development of vegetable production technology in protected areas, the matching drip irrigation technology has been widely used, and the fertilization method has been on the track of automation. The specific method of using the drip irrigation facility for topdressing is to install the fertilizer device at the water source into the drip irrigation main pipe, dissolve the chemical fertilizer in the fertilizer applicator, and insert the drip irrigation main pipe into the suction pipe filter of the fertilizer applicator, and the fertilizer can automatically enter the crop root system with the watering device. In the surrounding soil. Due to the mulching film, the fertilizer is almost non-volatile and has no loss. Although the fertilizer is concentrated, the concentration is small, so it is safe, labor-saving and labor-saving, and the effect is very good. This is a relatively scientific and highly promising method of topdressing, only to carry out strict film mulching. And you must have matching drip irrigation and tap water equipment to use.
Fifth, the root dressing outside the top dressing is the foliar spray fertilizer. Facility Horticulture and cultivation of vegetables, because the environment created by man-made is more convenient to meet the requirements of crops on environmental conditions, vegetables show the characteristics of fast growth, high yield and many results. In addition to paying attention to timely topdressing in the management, it can also be combined with spraying, and the root dressing is repeated several times to supplement the nutrient deficiency of the crop. This method is a cost-effective fertilization method because it has less dosage and quick fertilizer efficiency, and can avoid the fixation of fertilizer by soil. It can be used in the case of obvious deficiency and root senescence in the late stage of crop growth, and it can show its effect. In addition to urea, potassium dihydrogen phosphate, potassium sulfate, potassium nitrate, compound fertilizer and other commonly used large amount of elemental fertilizers, in recent years, many manufacturers in various places have developed suitable for foliar application. A large number of elements plus trace elements or fertilizers containing a variety of amino acid ingredients, such as spray Shibao, plant protection, farm music and so on. However, it must be noted that the basic nutrients required for the growth and development of vegetables are mainly derived from the base fertilizer and other methods of topdressing fertilizers. The external top dressing can only be used as an auxiliary measure.
[Automatic Switch, Free Your Hands]: Cabinet light has two working modes, Motion & Light Sensor Mode, Always On and Off Mode. In G mode, this counter light automatically turns on when it senses human motion within 10 feet in a dark environment, and automatically turns off after 20 seconds of inactivity. You can use these lights as normal light or safe light.
[Upgraded Version & More Bright Sensor Closet Light]: With 20 LEDs(Not 10 LEDs) for each light, up to 160 lumens, more bright than other LED closet lights in the market, very easy to find what you're looking for and perfect to light up in a large space where there is no light system, like the cabinet, wardrobe, stairs, etc. HIBOITEC motion sensor light is the best choice for you.
[Larger Battery Capacity & Rechargeable]: Built-in 1000 mAh high-capacity rechargeable battery, has larger battery capacity than other led cabinet lighting, easily to charged via USB. After fully charged, these closet lights last for up to 8 hours under on mode and last 1-2 months under motion sensor mode. NEVER replace AAA batteries frequently. Energy Save & Save More Money!
[Two Ways to Install]: Easy to install and remove without any other tools. Using Magnetic Back Design, can stick on any ironwork, allows you to change the its location you need. Or you can use the included tape to attach the iron to any non-ferrous product surface. When you need to charge or change position, you can take down the closet lights at any time.
Solar Motion Light,Best Outdoor Motion Sensor Lights,Indoor Motion Sensor Light,Outdoor Sensor Lights
Ningbo Wason Lighting Technology Co.,Ltd , https://www.wasonlight.com