The front engraving machine is full of enthusiasm because the manufacturers have added a lot of problems to the buyers. The introduction of the salesperson alone is only one aspect. The most important thing is to look at the structure of the product and the composition of each component. So, read a few key points so that you have a good idea when you buy.
1. Pay attention to the function of the engraving machine. The engraving motor of the stone engraving machine has high power and low power. Some engraving machines are only suitable for the processing of two-color boards, architectural models, small signage, three-dimensional handicrafts and other materials. This process has been popular for some time, but its engraving power is too small, which greatly affects its application range. The other is an engraving machine for high-power engraving heads. The engraving machine is divided into two categories, one is a large-format cutting machine: the width is generally more than one meter, but the precision of this engraving machine is generally poor; The class is a medium-sized engraving machine: this engraving machine is generally used for fine processing and organic sign making.
2, to understand the performance and function of the engraving motor, the engraving head motor of the engraving machine is also very important, because the engraving head motor is generally not covered by the warranty, and the engraving head motor is working continuously for a long time, so if the engraving head motor Bad will also affect the use of the engraving machine.
3, the other is the adjustable speed range of the engraving head motor, the general speed adjustable range is several thousand to 30,000 revolutions per minute, if the speed is not adjustable or the speed adjustable range is small, then the application range of the engraving machine is Subject to great restrictions
4. Manufacturing process of engraving machine body: When the high-power engraving machine works, the body must be precise and stable.
5, the controller is generally divided into two categories: one type of controller is only to do the drive, and all its calculation work is done by the computer. When the engraving machine is working, the computer is in a waiting state, and the typesetting work cannot be performed. Another type of controller is controlled by a single board machine or a single chip microcomputer. This kind of controller is actually a computer, so as long as the engraving machine starts working, the computer can immediately perform other typesetting work, especially when engraving for a long time. The advantages are particularly obvious.
Thread Rod
Hebei Qianmu Fastener Manufacturing Co., Ltd , https://www.qmjgjfasteners.com