The so-called pneumatic Tool refers to a tool that uses compressed air to drive the air motor to output kinetic energy. It is a kind of hardware product that is often used in modern construction and machinery industry. With pneumatic tools, it will work for people in related industries. Convenient, but the performance and methods of pneumatic tools also need attention, how to use and maintain pneumatic tools? See how Xiaobian can help you!
Methods and techniques for using and maintaining pneumatic tools:
1. Guarantee the correct generation gas supply system: the inlet pressure is at the inlet of the tool (the outlet pressure of the non-air compressor) is generally 90PSIG (6.2Kg/cm^2). The performance of the tool is too high or too low. life. The air intake must contain sufficient lubricating oil so that the air motor in the tool is fully lubricated (a white paper can be placed on the tool exhaust to check for oil stains, which is normal for oil stains). The intake air must be free of moisture. If the air is not air-dried, it is not appropriate.
2. Do not arbitrarily remove the parts of the tool and operate it. In addition to affecting the safety of the operator, the tool may be damaged.
3. If the tool is slightly faulty or cannot be used to achieve the original function, it can no longer be used. Check it immediately.
4. Use all kinds of tools, be sure to follow the various safety regulations and instructions for use.
5, to use the appropriate tools to work, the tool is too large to cause work damage, too small tools can easily cause damage to the tool.
6. Regularly (about once a week) inspect and maintain tools, add butter to the rotating parts such as bearings, and add oil to the air motor.
Of course, in order to ensure that the pneumatic tools will not be damaged during use, Xiaobian recommends that if you do not operate the pneumatic tools at all, it is best to find professional personnel for construction and use.
Concerned about surprises
Previous: Diamond Grinding Machine Operation Precautions Next: How to solve the anti-slip problem of ceramic floor tiles?
Center Drill Bit is also known as Slocombe Drills, Centre Drills were originally designed to create the countersink required to locate a tailstock centre when turning between centres. They have a point angle of 60° to match the angle of a Tailstock Centre.
A Centre Drill can also be used to provide a start location for a drill when drilling down the centre of a bar held in a Lathe chuck. Centre Drills are short and rigid enough to mark the bar centre without wandering off if they are carefully offered up to a rotating work-piece.
Carbide Center Drills,Hardware Tool Step Drill Bit,Wooden Box Packed Drill,Hss Center Drill Set
Behappy Crafts (suzhou)Co.,Ltd , https://www.jshaoyue.com