In order to maintain a good appearance and stable performance of the barrier, daily maintenance of the barrier is essential. So, what are the parking lot maintenance services? As a non-professional, how do you maintain it? Here we will give you an introduction.
External maintenance:
1. The cleaning and trimming of the gate bar, the bar above the bar will generally be covered with dust, managers should promptly clean up; In addition, if the reflective film of the brake bar off or degumming, should be repaired. This maintenance cycle is recommended once a month.
2, open the box to check the wire joints are tight, repair electrical contacts, check gear wear and limit switches should also check the fastening, check the maintenance cycle once a month.
3. Add lubricating oil to each rotating shaft and replenish the oil in the gearbox timely. If the capacitor has a spoiled oil leak, replace it immediately. This proposal is checked and maintained every month.
4. Keep the gate box clean and check whether the door and the box cover are sealed to prevent the entry of dust and rainwater. It is recommended to check and maintain it once a month.
Internal maintenance:
The movement is the heart of the machine and it must be maintained. It is recommended to maintain it once a month.
1. Cut off the power, open the cover of the brake, clean the surface dust, add the butter after cleaning the transmission part first, and apply some butter to the gear and wheel groove.
2. Check the fasteners and connecting rods for loosening and tighten them.
3. Check the wear of the wearing parts. The positioning arm and the positioning plate of the gate must be replaced with more than 3mm clearance. The normal clearance (1-1.5mm) should be properly added to the solenoid valve core to make the solenoid valve Reduce resistance during exercise and be lubricated. Be careful not to add too much. Be moderate.
4. Pay attention to the limit switch and the limit piece of the gate. Do not adjust it to prevent it from being too far or too close.
Note: The internal and external barriers should always pay attention to maintenance, a little bit of a problem, a long time will affect the use, so we must understand the importance of maintenance of the gate. The above-mentioned internal maintenance personnel must be professionally trained to fully understand the strengths and weaknesses before they can go on duty.
Single Handle Kitchen Faucets or taps frequently use one handle, more complex, valve controlled by a single handle (single handle mixer). The handle moves up and down to control the opening and turning off, and moves left and right to control the temperature of the water.
Single Handle Kitchen Faucets,Single Handle Kitchen Sink Mixer Tap,Single Lever Brass Kitchen Faucet,Single Handle Brass Mixer Faucet
Kaiping Jenor Sanitary Ware Co., Ltd , https://www.kpjenorsanitary.com