Shearing machine is a kind of shearing equipment widely used in machining. It can cut steel plate materials of various thicknesses. Commonly used shearing machines are divided into three types: flat shear, rolling shear and vibration shear. The flat shears are used in large quantities. Shearing machines with a shear thickness of less than 10 mm are mostly mechanical transmissions, and those with a thickness greater than 10 mm are hydraulically driven. Single or continuous shearing of the metal is typically performed using a foot or button manipulation. Pay attention to the operation of the shearing machine:
(1) Before work, carefully check whether the various parts of the shearing machine are normal, whether the electrical equipment is intact, whether the lubrication system is unblocked, and the tools and measuring tools such as tools and measuring tools and corner scraps are placed on the surface of the table.
(2) Do not operate the shearing machine by one person alone. It should be coordinated by 2-3 people to carry out feeding, control dimensional accuracy and reclaiming materials, and be determined to be unified by one person.
(3) Adjust the scissors gap of the shearing machine according to the specified thickness of the shearing plate. It is not allowed to cut two kinds of sheets of different specifications and different materials at the same time; The cut sheet requires a flat surface and is not allowed to cut narrower sheets that cannot be compressed.
(4) Protective covers must be installed on the moving parts of the belt, flywheel, gears and shafts of the shearing machine.
(5) The finger of the shearer operator should keep a distance of at least 200mm from the scissors opening and leave the pressing device. The protective fence placed on the trigger can't block the operator's eyes and can't see the cut. The waste generated after the operation is angular and the operator should remove it in time to prevent stab wounds and cuts.
(6) The protective parts of the flywheel, gear, shaft, tape and other moving parts of the shearing machine shall be provided.
(7) Place a fence to prevent the operator's hand from entering the area where the scissors fall. It is strictly forbidden to pick up the waste on the ground during work to avoid being injured by the falling workpiece.
(8) It is impossible to cut the quenched material, and it is never allowed to cut the working ability beyond the shearing machine.
Plant Growth Light,Plant Growing Lamp,Phyto Lamp,Plant Light
SHENZHEN LITEHOME OPTOELECTRONIC TECHNOLOGY CO., LTD. , https://www.litehomelight.com