Tool Scaffolding Work Safety Measures

1. The use of a tool scaffold must be designed and compiled with a construction plan and approved by the person in charge of the technical department.
2. Enterprises engaged in the construction of adhering lifting scaffolds must obtain the qualification of “adhesion lifting scaffold professional contracting”.
3. Adhesion lifting scaffolds must comply with the Interim Provisions on the Administration of Attached Scaffolds for Construction (No. 230 [2000]). Attached lifting scaffolding (including pylon, hanging basket) Construction work surface must be laid solidly and tightly with a scaffolding plate. An 18 cm high footrest plate is to be provided. The frame body is closed along the inner side of the outer row with a dense mesh safety net. Two 1.2-meter-high body-guard rails shall be added on the inside, and a body-guard railing shall be set up on the outside of the work surface. The safety net should be woven around the bottom of the scaffold board.
4, outside the basket and both sides of the application of dense mesh safety net tightly sealed. In the course of using the lifting scaffolds, hangers, hanging baskets, etc., the first level of horizontal safety net must be set in accordance with the operating standards of the high places, and the hanging baskets should be firmly attached to the buildings.
5. An independent safety rope must be used when the basket is lifted and lowered. The rope diameter is not less than 12.5 mm. The operator wears a safety belt.
6. The length of the cantilevered beam must be perpendicular to the steel wire rope of the hanging basket. Effective measures must be taken to ensure that the strength, rigidity, and stability of the cantilever beam can meet the construction safety requirements. The rope has measures to prevent it from being separated from the cantilever beam. After the riveting of the basket, the reserved rebar ring should have sufficient strength. After the riveting, the strength of the building must meet the construction requirements.
7. The hanging basket length must not exceed 6 meters.
8. The hanging point of the external hanger adopts the bolt through the wall. The bolt through the wall must have enough strength to meet the construction needs. The bolts are used to padded the plate and fastened with double nuts. The structural strength of the building at the suspension point must meet the construction requirements.
9. Take measures to prevent shear damage to the wire rope at the contact point between the wire rope and the angular object.
10. The elevator well bearing platform and material turnover platform must develop a special program and perform acceptance procedures.
11. The scaffold board on the material turnover platform shall be tightly secured with a protective fence not less than 1.5m around the platform. The inner side of the fence shall be sealed with a dense mesh safety net, and the lower mouth shall be set with a 18-cm footrest plate. For the erection of articles, the platform shall be provided with signage in obvious places, specifying the use requirements and limiting the load.

China Labor Insurance Network